收藏本站
Si10xx-DK
3.7. Keil μVision2 and μVision3 Silicon Laboratories Drivers
As an alternative to the Silicon Laboratories IDE, the μVision debug driver allows the Keil μVision2 and μVision3
IDEs to communicate with Silicon Laboratories’ on-chip debug logic. In-system Flash memory programming
integrated into the driver allows for rapid updating of target code. The μVision2 and μVision3 IDEs can be used to
start and stop program execution, set breakpoints, check variables, inspect and modify memory contents, and
single-step through programs running on the actual target hardware. For more information, refer to the μVision
driver documentation. The documentation and software are available on the kit CD and from the downloads
webpage: www.silabs.com/mcudownloads .
4. Hardware Setup using a USB Debug Adapter
The motherboard is connected to a PC running the Silicon Laboratories IDE via the USB Debug Adapter as shown
in Figure 6.
1. Connect the USB Debug Adapter to the DEBUG connector on the motherboard with the 10-pin ribbon cable.
2. Connect one end of the USB cable to the USB connector on the USB Debug Adapter.
3. Verify that a shorting block is installed on J17 and that SW5 is in the ON position.
4. Connect the other end of the USB cable to a USB Port on the PC.
5. Connect the ac/dc power adapter to power jack P1 on the target board (Optional).
Notes:
?
?
Use the Reset button in the IDE to reset the target when connected using a USB Debug Adapter.
Remove power from the target board and the USB Debug Adapter before connecting or disconnecting the
ribbon cable from the target board. Connecting or disconnecting the cable when the devices have power can
damage the device and/or the USB Debug Adapter.
PC
Motherboard with Daughtercard Attached
R15
J16
J15
J18
P4
SILICON LABS
www.silabs.com
J6
TOUCH SENSE SWITCH
P0.6
J4
P1.6
P1.5
P0.2 P0.3
USB POWER P3
CP
2103
U3
J9
USB Debug
Adapter
USB
J19
J8
+1VD
J11
J12
Cable
J20
J3
J7
J13
J14
COIN_CELL
AAA_BAT
WALL_PWR
+3VD
VBAT
RESET
VDD/DC+
IMEASURE
H1
J5
`
J2
OFF
ON
SW5
J17
H2
VBAT
J1
SW4
P2
AC/DC
Adapter
Figure 6. Hardware Setup using a USB Debug Adapter
Rev. 0.1
7
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
SI1021R-T1-GE3 MOSFET P-CH 60V 190MA SC-75A
SI1022R-T1-GE3 MOSFET N-CH 60V 330MA SC-75A
SI1024X-T1-GE3 MOSFET DL N-CH 20V 485MA SC89-6
SI1025X-T1-GE3 MOSFET P-CH 60V 190MA SC-89
SI1029X-T1-GE3 MOSFET N/P-CH 60V SC89-6
SI1031X-T1-E3 MOSFET P-CH 20V 155MA SC-75A
SI1033X-T1-GE3 MOSFET 2P-CH 20V 145MA SC89
SI1037X-T1-E3 MOSFET P-CH 20V 770MA SC-75A
相关代理商/技术参数
SI1011 制造商:SILABS 制造商全称:SILABS 功能描述:Ultra Low Power, 16/8 kB, 12/10-Bit ADC MCU with Integrated 240-960 MHz EZRadioPRO Transceiver
Si1011-A-GM 功能描述:射频微控制器 - MCU 8kB 768B RAM programmable XCVR RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:Si100x 数据总线宽度:8 bit 最大时钟频率:24 MHz 程序存储器大小:64 KB 数据 RAM 大小:4 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LGA-42 安装风格:SMD/SMT 封装:Tube
SI1011-A-GMR 功能描述:射频微控制器 - MCU 8kB 768B RAM +20 dBm programmable XCVR RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:Si100x 数据总线宽度:8 bit 最大时钟频率:24 MHz 程序存储器大小:64 KB 数据 RAM 大小:4 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LGA-42 安装风格:SMD/SMT 封装:Tube
Si1011-C-GM2 制造商:Silicon Laboratories Inc 功能描述:8KB 768B RAM 20DB XCVR QFN42 制造商:Silicon Laboratories Inc 功能描述:RF Microcontrollers - MCU 8kB, 768B RAM +20 dBm
SI1011-C-GM2R 制造商:Silicon Laboratories Inc 功能描述:8KB, 768B RAM, +20 DBM, PROGRAMMABLE XCVR - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC MCU 8KB FLASH EZ PRO 42LGA 制造商:Silicon Laboratories Inc 功能描述:RF Microcontrollers - MCU 8kB 768B RAM +20 dBm programmable XCVR
SI1012 制造商:SILABS 制造商全称:SILABS 功能描述:Ultra Low Power, 16/8 kB, 12/10-Bit ADC MCU with Integrated 240-960 MHz EZRadioPRO Transceiver
Si1012-A-GM 功能描述:射频微控制器 - MCU 16kB 768B RAM programmable XCVR RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:Si100x 数据总线宽度:8 bit 最大时钟频率:24 MHz 程序存储器大小:64 KB 数据 RAM 大小:4 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LGA-42 安装风格:SMD/SMT 封装:Tube
SI1012-A-GMR 功能描述:射频微控制器 - MCU 16kB 768B RAM +13 dBm Prog XCVR RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:Si100x 数据总线宽度:8 bit 最大时钟频率:24 MHz 程序存储器大小:64 KB 数据 RAM 大小:4 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LGA-42 安装风格:SMD/SMT 封装:Tube